COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014 495
Service and Maintenance
Selecting a PBX
Data Backup to SD Card
Selecting a PBX
The configuration of the telephone is dependent on the PBX that it is run on. In order to precon-
figure a telephone for operation in another PBX (for example, for service calls), configure the
system to be valid ahead of time. Ignore the error message and configure the desired preset-
tings using the COMfortel Set. If you select another PBX instead of COMpact 3000 analogue/
ISDN/VoIP, COMpact 5010 VoIP, COMpact 5020 VoIP, COMpact 5000/R and COMmander
6000/R/RX (or vice versa), the existing configuration is irrevocably deleted.
The selection can be carried out as follows:
• Using the telephone
1. Press the menu key and open the menu settings > synchronisation > select PBX.
2. Select the desired PBX.
The telephone restarts.
Note: If the wrong PBX is selected, this is detected and an error message is
displayed. If the setting for a wrong PBX is made on purpose for service
reasons, the error message must be ignored.
Comments to this Manuals