Auerswald COMfortel 1400 Service Manual Page 282

  • Download
  • Add to my manuals
  • Print
  • Page
    / 562
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 281
282 COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014
Functions
Power Save Mode
Switching Automatic Activation of Power Save Mode On/Off
Power Save Mode
In power save mode, the display lighting and the LEDs are inactive (exception: the message
LED blinks for missed calls).
After a configurable waiting time and depending on the configuration, power save mode can be
activated automatically during the switchover into a PBX configuration and/or manually by
pressing a key. Power save mode is deactivated again as soon as an incoming call is signalled
or any key is pressed.
Switching Automatic Activation of Power Save Mode On/Off
If automatic activation of power save mode is enabled, the telephone automatically switches
into power save mode when the telephone is not in use.
The holding time indicates how much time after the key was last pressed before power save
mode is activated.
Switching this on/off can be done as follows:
Using COMfortel Set
Using the telephone
Using COMfortel Set to Switch Automated Activation of Power Save Mode On/Off
1. Open the page Settings/functions > Power save mode.
2. Select or clear the Automated activation check box.
3. Enter a value in the corresponding Waiting time (1 to 999 minutes) entry field. The
following entries are possible:
Further steps:
– Save your configuration before closing.
Enables the automated activation of power save mode.
Disables the automated activation of power save mode.
1 to 999: After 1 to 999 minutes, power save mode is automatically activated,
depending on the entry.
Page view 281
1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 561 562

Comments to this Manuals

No comments