Auerswald COMfortel 1400 Service Manual Page 444

  • Download
  • Add to my manuals
  • Print
  • Page
    / 562
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 443
444 COMfortel 1400 - Firmware Version 1.4 - COMfortel Set V3.6 - Operation and Configuration V01 04/2014
Settings
Protection from Unauthorised Access
Configuring a Function Lock
Configuring a Function Lock
The functions available in the function menu and key definition menu can be blocked from
unauthorised use. The display of these restricted functions in the selection list requires entering
the corresponding PIN after selecting additional at the end of the selection list.
Note: A function key defined with a restricted function cannot be used with
out entering a PIN. This means that the administrator can, for example,
enable the switching on/off of a specific call forwarding configuration via the
function key even though the ability to configure any number of call forwarding
configurations is restricted.
The configuration can be carried out as follows:
Using COMfortel Set
Using the telephone
Using COMfortel Set to Configure the Function Lock
1. Open the page Settings/functions > Restrictions.
2. Click the Telephone menu functions tab.
3. Select one of the following options for the function to be blocked.
If you would like to restrict all of the functions, select one of the following options under
All - restricted for.
Further steps:
No restrictions: The function is not blocked.
Guests: Blocks the function in question from guests.
Guests + users: Blocks the function in question from guests and users.
Guests + users + SubAdmin: Blocks the function in question from guests,
users and sub-administrators.
No restrictions: No function is blocked.
Guests: Blocks all functions for guests.
Guests + users: Blocks all functions for guests and users.
Guests + users + SubAdmin: Blocks all functions for guests, users
and sub-administrators.
Page view 443
1 2 ... 439 440 441 442 443 444 445 446 447 448 449 ... 561 562

Comments to this Manuals

No comments